HP 5120 SI Series

319
IPsec configuration commands
IPsec configuration commands are available only for the switches in FIPS mode. For more information
about FIPS mode, see Security Configuration Guide.
ah authentication-algorithm
Syntax
ah authentication-algorithm sha1
undo ah authentication-algorithm
View
IPsec proposal view
Default level
2: System level
Parameters
sha1: Uses SHA1.
Description
Use the ah authentication-algorithm command to specify an authentication algorithm for the
authentication header (AH) protocol.
Use the undo ah authentication-algorithm command to restore the default.
By default, SHA-1 is used.
Before specifying the authentication algorithm for AH, be sure to use the transform command to specify
the security protocol as AH or both AH and ESP.
Related commands: ipsec proposal and transform.
Examples
# Configure IPsec proposal prop1 to use AH and SHA1.
<Sysname> system-view
[Sysname] ipsec proposal prop1
[Sysname-ipsec-proposal-prop1] transform ah
[Sysname-ipsec-proposal-prop1] ah authentication-algorithm sha1
connection-name
Syntax
connection-name name
undo connection-name
View
IPsec policy view