HP 5335A - Page 16

Installation
2-42. OTHER PACKAGING. The following general instructions should be used for repacking
with commercially available materials:
a. Wrap instrument in heavy paper or plastic. (If shipping to Hewlett-Packard office or
service center, attach tag indicating type of service required, return address, model
number, and full serial number.)
b. Use a strong shipping container. A double-wall carton made of 350-pound test material
is adequate.
i CAUTION i:
The Instrument front handles must be left attached to avoid
damage to controls.
c. Use a layer of shock-absorbing material 70 to 100 mm (3- to 4-inch) thick around all sides
of the instrument to provide firm cushioning and prevent movement inside container.
Protect control panel with cardboard.
d. Seal shipping container securely.
e. Mark shipping container FRAGILE to ensure careful handling.
f. In any correspondence, refer to instrument by model number and full serial number.
2-8
Model 5335A