HP 5400 zl

2-15
Installing the HP 5400 zl Switches
Installation Procedures
Installing the HP 5400 zl
Switches
Equipment
Cabinet
Note
If you are installing the switch in an equipment cabinet, in place of the
12-24 screws supplied with the switch, use the clips and screws that came with
the cabinet. Plan which four holes you will be using in the cabinet and install
all four clips and partially install the two bottom screws, as described in step
2 on the previous page, before proceeding to step 3.
WARNING For safe operation, please read the “Installation Precautions” on page
2-4 and page 2-5 before mounting the switch.
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
For the 5406 zl switches, each bracket is attached with four screws as
shown in the following illustration.
Although these procedures show the 6-slot chassis, the procedures are
the same for the 12-slot chassis.
Figure 2-7. Attaching brackets to the 5400 zl switch
8 mm
M4 screws