HP 54520 Series - Page 123

Figure 7-1
Marker Menu
This chapter describes how to use the markers and make manual
measurements on displayed waveforms.
In this menu, two sets of x and y axis markers are provided, each with
a separately selectable source. The x markers (horizontal) measure
voltage (or power in FFT mode), and the y markers (vertical)
measure time (or frequency in FFT mode) for the currently selected
source. Each marker is individually controlled and labeled.
When you press the Marker key on the front panel, the marker menu
is displayed on the right hand portion of the screen. The marker
menu and menu map are shown below.
Marker
MARKER
off on
- source xl. yl
PChannel 1 |
- x1 position —
- yl position —
- source x2, YZ
- x2 position —
400, 00000 US
- y2 position —
1.50000 V
BURSELED
7-2