HP 54520 Series - Page 152

Waveform Save Menu
Waveform Save Menu
Source Softkey
The source softkey selects the source waveform to store in the selected
memory. You can select any channel or function as a source.
Store Softkey
The store softkey is the active softkey in the menu. When pressed, the
memory is erased and new data is stored to the memory. If the destination
memory is protected, the message "protect on: cannot store waveform" is
displayed, indicating that the store was not successful.
Protect Softkey
The protect softkey toggles the selected waveform memory write-protect
to on or off. When on is selected, any attempt to store data is not allowed,
and the message "protect on: cannot store waveform" is displayed, indicating
that the store was not successful.
Timebase/Delay Softkey
The time base delay softkey is displayed when the selected memory is
turned on. It initially displays the time base and delay settings when the
waveform was stored. Pressing the softkey cycles between the time base and
delay values. If the data was saved in the real-time mode, you can use the
knob to change the values to pan and zoom displayed waveforms.
9-5