HP 54520 Series - Page 41

Front-Panel Overview
Display
There is a ground marker on the left side of the display for each channel that
is turned on. The ground markers give you a visual indication of where the
ground reference point is for each channe! that is turned on. When a channel
is turned on, the gournd marker is displayed and the channel number is
displayed above the ground marker. If the ground reference for a channel is
positioned vertically off the screen, the ground marker turns into an arrow
that points in the direction of the ground reference. Ground markers are
printed with hardcopy prints. You can turn the ground markers on or off with
the gnd markers softkey in the Utility/system menu/system util menu.
There is a channel marker on the right side of the display for each channel
that is turned on. The channel markers help you keep track of the source
channel for each displayed waveform. The channel labels are printed with
hardcopy prints. You can turn the channe! lables on and off with the chan
labels softkey in the Utility/system menu/system util menu.
The volts/div and offset (channel factors) settings for each channel that is
turned on are displayed on the screen. If measurements are turned off, the
channel factors are displayed below the graticule area. If measurements are
turned on, the channel factors are displayed near the bottom of the graticule
area. You can turn on or off the display of the channel factors with the chan
factors softkey in the Utility/system menu/system util menu. You can also
press the Show front-panel key to see the complete setup of any channels
that are turned on. The channel factors are printed with hardcopy prints.
2-18