HP 54520 Series - Page 43

See also
Front-Panel Overview
Instrument Reset
Instrument Reset
The oscilloscope has two methods of instrument reset: key-down power up or
Recall clr.
Key-Down Powerup A key-down power up is a hard reset of the
oscilloscope. It is done by pressing and holding any front-panel key while
cycling power.
The oscilloscope powers up displaying a baseline, the show screen, and the
front-panel configuration is set to the default settings. Except for the
following additions, the default settings are the same as those in table 2-1.
Utility Menu (HP-IB menu)
Address/talk Address
Address 7
Recall Clr (Clear) Recall clr (clear) is a soft reset that sets the scope
to the default conditions in table 2-1. Performing a recall clear is similar
to a key-down power-up except the previous menu selections are
retained.
Disk Drive
The oscilloscope has a high-density, 3-1/2 inch, Ms-bos® compatible disk
drive. In the disk menu you can save and recall waveforms, save and recall
front-panel setups, delete files from a disk, format a disk, or obtain a
directory listing of a disk. You can also use the disk drive to load new system
firmware into the flash ROMs or you can load applications.
Chapter 12, "Disk Menu" for information about the disk menu and its features.
MS-DOS® is a US registered trademark of Microsoft Corporation.
2-20