HP 54520 Series - Page 60

Horizontal
Pan and Zoom
Pan and Zoom This exercise shows how to use the time base to zoom in and to zoom out on
Exercise a single-shot waveform. Then, you use delay to pan the waveform
horizontally on the display.
Press the Recall key. Then, press the Clr key.
Connect a coaxial cable between the rear-panel AC connector and
channel 1.
Press the Autoscale key.
3
4 Use the time/div knob to change the time base to 500 ps/div.
5
6
Ld
Press the Horizontal Setup key. Then, select the real-time mode.
Press the record length softkey. Then, use the entry knob to set
the record length to 8192 points.
Figure 4-1 4e running HORTZONTAL
- reference
lett GMM right
Fepetitive
[realtime ]
cone = pre see Sh - sequential —
on
—recard length
-2.50000 ms 9.00000 5§ 2.50000 ms
500 us/div realtime
ATI. ec just
100 kSa/s
—sample clock —~
an
4-7