HP 54522A - Page 67

Horizontal
Repetitive/Real Time Softkey
Repetitive This exercise shows the single-shot capabilities of the oscilloscope in the
Single-Shot repetitive mode. The exercise uses single-shot acquisitions in the repetitive
Exercise mode to build a waveform while displaying the 2-GSa/s sample rate.
1 Press the Recall key. Then, press the Clr key.
hai 2 Connect a coaxial cable between the rear-panel AC connector and
channel 1.
3 Press the Autoscale key.
4 Use the time/div knob to change the time base to 2 ns/div. Then, use
Delay knob to horizontally move the signal so it is slightly to the right
of center screen.
5 Press the Horizontal Setup key. Then select the repetitive mode.
Figure 4-4 Ap running HORIZONTAL
| 2,00 nena |
2 GSe/s
- delsy
aa aT
- reference ——
| vert Gar ght
repetitive
|
realtime
fi a tS
-36.400 ns 23.400 ns 13.400 ns
2.00 ns/div repetitive