HP 54540 Series - Page 126

Marker Menu
Source x2, y2 Softkey
Source x2, y2 Softkey
The operation is identical to source x1, yl softkey, except that the source is
specified for the x2 and y2 markers.
x2 position Softkey
Operation is identical to x1 position softkey, except that the x2 marker is the
vertical marker with shorter dashes, and is marked on the bottom of the
display as "x2."
y2 position Softkey
Operation is identical to yl position softkey, except y2 marker is the
horizontal marker with shorter dashes, and is marked on the right side of the
display as “y2."
Markers and Measurements
Automatic measurements are usually made on waveforms displayed on the
screen. One way you can make custom measurements with the markers is by
placing them on the portion of the displayed waveform you are interested in.
Then, reading the values directly from the x and y marker positions, or
reading the differential values using the delta x and delay y values.
Another way to make custom measurements is by setting the meas window
softkey to markers in the define measure menu. Then, you can use the
markers to window on the displayed waveform, and you can use the
automatic measurements to make the measurement.
If the continuous softkey in the define measure is turned off, the markers are
automatically turned on and they are placed on the displayed waveform
showing you where the measurement was made.
7-5