HP 54540 Series - Page 130

Define Measure Menu
Measurement Selection
Measurement Selection
Each key on the keypad has a secondary function. Above each key is a
measurement selection printed in blue.
Make sure the measurement source is on. For example, if the measurement
source is channel 3, make sure that channel 3 is turned on by checking the
vertical menu or by looking at the LED by the channel 3 front-panel key.
am a ITER EI ME et EPP P EPP E ATT ITT RAT RET PEER
To make a measurement:
1 Press the blue shift key.
2 Press the key that corresponds to the measurement you are making.
3 Use the Entry knob to select the measurement source.
The current measurement source is shown, in inverse video, next to the
selected measurement on the display: channel number, c#; memory number,
m#; or function number, f#.
4 Use the keypad to select the correct channel, function, or waveform
memory.
To clear measurements from the display:
Press the blue shift key. Then, press the Clr meas key.
See also Chapter 13, "Measurements," for complete details on measurement
definitions and algorithms.
8-3