HP 54540 Series - Page 22

Setting Up the Oscilloscope
Rear Panel
Verifying the Fuse
If it is necessary to check or change fuses, remove the fuse module and check
each fuse for its amperage and voltage ratings.
Figure
1-3
A
orssvioa
Fuse location on fuse module
Intensity Control
After turning on the oscilloscope, you can adjust the display intensity with
the display intensity control on the rear panel.
Air Flow Requirements
Make sure the oscilloscope has unrestricted air flow for the fan and
ventilation openings in the rear panel. You can stack the oscilloscope under,
over, or between other instruments provided the other instruments are
adequately cooled.
1-7