Nonblocking architecture
up to 192 Gb/s nonblocking switching fabric provides wire-speed switching with up to 143 million pps throughput
Hardware-based wirespeed access control lists (ACLs)
help provide high levels of security and ease of administration without impacting network performance with a feature-rich
TCAM-based ACL implementation
Resiliency and high availability
Separate data and control paths
: keeps control separated from services and keeps service processing isolated; increases
security and performance
External redundant power supply
: provides high reliability
Smart link
: allows 50 ms failover between links
Spanning Tree/MSTP, RSTP
: provides redundant links while preventing network loops
Rapid Ring Protection Protocol
(RRPP): connects multiple switches in a high-performance ring using standard Ethernet
technology; traffic can be rerouted around the ring in less than 50 ms, reducing the impact on traffic and applications
Virtual Router Redundancy Protocol
(VRRP): allows a group of routers to dynamically back each other up to create highly
available routed environments
Intelligent Resilient Framework
(IRF): creates virtual resilient switching fabrics, where two or more switches perform as a
single L2 switch and L3 router; switches do not have to be co-located and can be part of a disaster recovery system; servers or
switches can be attached using standard LACP for automatic load balancing and high availability; can eliminate the need for
complex protocols like Spanning Tree Protocol, Equal-Cost Multipath (ECMP), or VRRP, thereby simplifying network operation
IP Fast Reroute
(FRR): forms backup paths and allows 50 ms switchover in case of a main path fault
Layer 2 switching
32K MAC addresses
: provide access to many Layer 2 devices
IEEE 802.1ad QinQ and Selective QinQ
: increase the scalability of an Ethernet network by providing a hierarchical structure;
connect multiple LANs on a high-speed campus or metro network
GARP VLAN Registration Protocol
: allows automatic learning and dynamic assignment of VLANs
IEEE 802.1ad QinQ
: increases the scalability of an Ethernet network by providing a hierarchical structure; connects multiple LANs
on a high-speed campus or metro network
10 GbE port aggregation
: allows grouping of ports to increase overall data throughput to a remote device
Internet Group Management Protocol
(IGMP)
and Multicast Listener Discovery
(MLD)
protocol snooping
: effectively control
and manage the flooding of multicast packets in a Layer 2 network
Layer 3 services
Address Resolution Protocol
(ARP): determines the MAC address of another IP host in the same subnet
Dynamic Host Configuration Protocol
(DHCP): simplifies the management of large IP networks and supports client and server;
DHCP Relay enables DHCP operation across subnets
Loopback interface address
: defines an address in Routing Information Protocol (RIP) and Open Standard Path First (OSPF),
improving diagnostic capability
User Datagram Protocol
(UDP)
helper function
: allows UDP broadcasts to be directed across router interfaces to specific IP
unicast or subnet broadcast addresses and prevents server spoofing for UDP services such as DHCP
Route maps
: provide more control during route redistribution; allow filtering and altering of route metrics
Layer 3 routing
IPv4 routing protocols
: support static routes, RIP, OSPF, ISIS, and BGP
IPv6 routing protocols
: provide routing of IPv6 at wire speed; support static routes, RIPng, OSPFv3, IS-ISv6, and BGP4+ for IPv6
QuickSpecs
HP 5500 EI Switch Series
Overview
DA - 13808 North America — Version 27 — January 16, 2014
Page 3
To Next Page
Loading...
Need help?
General