HP 556dn

●
TCP/IP
●
IPV 6 Settings
●
Address
●
Manual Settings
●
Enable
3. Select the On option, and then touch the Save button.
4. To congure the address, touch the Address button and then touch the eld to open a keypad.
5. Use the keypad to enter the address, and then touch the OK button.
6. Touch the Save button.
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the printer in automatic mode. Incorrect changes to the link speed and duplex settings might
prevent the printer from communicating with other network devices. To make changes, use the printer
control panel.
NOTE: The printer setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the printer to turn o and then on. Make changes only
when the printer is idle.
1. From the Home screen on the printer control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Network Settings
●
Jetdirect Menu
●
Link Speed
3. Select one of the following options:
●
Auto: The print server automatically congures itself for the highest link speed and communication
mode allowed on the network.
●
10T Half: 10 megabytes per second (Mbps), half-duplex operation
●
10T Full: 10 Mbps, full-duplex operation
●
10T Auto: 10 Mbps, automatic-duplex operation
●
100TX Half: 100 Mbps, half-duplex operation
●
100TX Full: 100 Mbps, full-duplex operation
ENWW Congure IP network settings 85