HP 6038A Service Manual

Section If
INSTALLATfOl^
2-1 INTRODUCTION
2-2 This section contains instructions for checking and
repacking the unit, bench or rack mounting, connecting the
unit to ac input power, and converting the unit from one line
voltage to another if required, instructions for connecting load
and HP-IB cables, and for setting the HP-IB address are given
In Section III.
2-3 INITIAL INSPECTION
2-4 Before shipment, this instrument was inspected and
found to be free of mechanical and electrical defects. As soon
as the instrument is unpacked, inspect for any damage that may
have occurred in transit. Save ail packing materials until the
inspection is completed, if damage is found, file claim with car¬
rier immediately. The Hewlett-Packard Sales and Service of¬
fice should be notified as soon as possible.
2-5 Mechanical Check
2-6 This check should confirm that there are no broken
knobs or connectors, that the cabinet and panel surfaces are
free of dents and scratches, and that the meter face and rear-
panel terminal block covers are not scratched or cracked.
2-7 Electrical Check
2-8 Section V contains complete verification procedures for
this instrument. Section III contains an abbreviated check which
can be used quickly to place the unit into operation. Refer to
the inside front cover of the manual for Certification and War¬
ranty statements.
2-9 PREPARATION FOR USE
2-10 In order to be put into service, the power supply must
be connected to an appropriate ac input power source. Also,
2-1

HP 6038A Specifications

General

Brand	HP
Model	6038A
Category	Inverter
Language	English