HP 6038A Service Manual

Table 3-7. HP-IB Commands
Command
•Range
or
••Response
to Query
Description
Paragraph
[VSET X
VSET xV
VSET xMV
*0^ 61.425 V
*0-61425 MV
Any of these commands is used to
program output voltage.
Initial Condition: 0 V
3-123-3-124
•0-10.2375A
•0-10237.5MA
Any of these commands is used to
program output current.
Initial Condition: 0 A
3-127-3-128
VSET?
ISET?
**VSET xx.xxx
**ISET xx.xxx
Used to read voltage and current
settings.
3-125, 3-129
VOUT?
iOUT?
**VOUT xx.xxx
**}OUT xx.xxx
Used to measure and read output
voltage or current.
3-126, 3-130
OVP?
**OVP xx.xx
Causes power supply to measure OVP
setting (which is hardware set at front
panel).
3-131
rVMAX X
VMAX xV
VMAX xMV
*0-61.425V
•0-61425MV
Any of these commands is used to
program an upper limit (soft limit)
on the voltage programming value that
the power supply will accept.
Initial Condition: 61.425V
3-132, 3-133
f IMAX X
IMAX xA
IMAX xMA
•0-10.2375A
•0-10237.5MA
Any of these commands is used to
program an upper limit (soft limit)
on the current programming value
that the power supply will accept.
Initial Condition: 10.2375A
3-132, 3-133
VMAX?
IMAX?
**VMAX xx.xxx
**IMAX xx.xxx
Used to read voltage and current
limits (soft limits).
3-134
rblY X
DLY xS
DLY xMS
*0 - 31.999S
•0- 31939MS
Any of these commands is used to program
the delay time after a new output voltage or
current is implemented, or RST or OUT ON
command is received. During delay time
power supply disables CV, CC, and OR
conditions from being labeled as faults, and
disables foldback protection.
Initial Condition; 0.5 s
3-135-3-138
DLY?
**DLY xx.xxx
Used to read delay time setting.
3-139
pDUT OFF
OUTO
L.
OUT ON
Lout i
Enables or disables power supply
output. Power supply remains able to imple¬
ment commands even while output is
disabled.
Initial Condition; OUT ON
3-141 __ 3-143
3-15

HP 6038A Specifications

General

Brand	HP
Model	6038A
Category	Inverter
Language	English