To Next Page

To Previous Page

SIM

NOTE: This section applies only to computer models with WWAN capability.

NOTE: If there is a SIM inserted in the SIM slot, remove it before disassembling the computer. Be sure

the SIM is reinserted in the SIM slot after reassembling the computer.

Before removing the SIM, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and

then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 48).

Remove the SIM:

1. Press in on the SIM (1). (The module is partially ejected from the SIM slot.)

2. Remove the SIM (2) from the SIM slot.

Reverse this procedure to install the SIM.

Component replacement procedures 49

Questions and Answers:

Need help?

Do you have a question about the HP 6710b - Compaq Business Notebook and is the answer not in the manual?

HP 6710b - Compaq Business Notebook Specifications

General