HP 70000 series - Page 306

Repair
Procedures
If
a
module
or
instrument
in
an
HP
70000 Series modular spectrum analyzer system requires
repair
,
the
customer
may
choose
to
do
the repair, or return the module or instrument to the
nearest
Hewlett-P
ackard
service
oce
.
Repair by Customer
This section discusses where the customer who chooses to do his own repairs can locate
assembly- or component-level repair information.
Support information is available for HP 70000 Series modular spectrum analyzer systems and
lightwave signal analyzers. This section explains where to locate repair information.
Module-Level Support
F
or
instructions
for
returning
a
faulty
module
to Hewlett-Packard, refer to the HP 70000
Modular
Spectrum
Analyzer
Installation
and
V
erication
Manual
.
Assembly/Component-Level
Support
For assembly-level troubleshooting information and ordering information for both new
and exchange assemblies, refer to the appropriate technical reference, service manual, or
component level information package (CLIP).
CA
UTION
Repairs
should
be
performed only at a static-safe work station. Refer to the
HP
70000
Modular
Spectrum Analyzer Installation and Verication Manual .
Note
Defective
units
must
be returned for trade-in when ordering exchange units.
CA
UTION
Do not apply more than 8 inch-pounds maximum torque (nger tight) when
reinstalling
any
connector
(for example, BNC, SMA). The connector may be
damaged.
Troubleshooting 5-27