HP 70000 series - Page 337

Hardware
Broken
Errors
7000
{
7999
7029
Video proc: 0 volt
Video processor: 0 volt error
Cause: The video processor is not able to be properly calibrated to the 0 volt reference. This
error will only occur on power up of the system, or when the TEST command is invoked, either
from
the
front
panel
or
remotely
.
Cure:
Return
to
Hewlett-P
ackard
for
servicing.
7030
Video proc: 2 volt
Video processor: 2 volt error
Cause: The video processor is not able to be properly calibrated to the 2 volt reference. This
error will only occur on power up of the system, or when the TEST command is invoked, either
from the front panel or remotely.
Cure: Return to Hewlett-Packard for servicing.
7031
Idler
is
unlocked
Cause:
The
local
oscillator
is
not
able
to
acquire
phase
lock.
Cure:
V
erify an external reference if applicable, otherwise the module will need to be returned
to
Hewlett-P
ackard for servicing.
7032
Oven RF error
The HP 70310A precision frequency reference accessory oven is not providing a signal, is
providing a low signal, or is providing a signal when it should not be.
7033
Power supply error
One or more of the +5 V, 0 12 V,or 0 5 V voltages are out of spec.
7034
Dist amp A error
Either the input to the HP 70310A precision frequency reference Distribution Amplier \A"
board assembly is beyond the specied operating range
, or a hardware failure exists. The most
probable causes are either: (a) one or more outputs are unleveled due to faulty HP 70310A
precision frequency reference hardware, or (b) an input that is too low in power.
6-30 Error Messages