HP 70000 series - User-Defined Function Management

Example 1-4. Remove a user softkey.
Press 4
USER
5
Any blank softkey
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DEFINE USR KEY
Press the softkey you wish to blank.
Incorporating User-Dened Functions into the User-Softkey Menu
The menu of user softkeys can be congured with user-dened functions that have been stored
in internal memory. User-dened functions are created and stored most eciently with a
computer program sent to the analyzer via HP-IB. Refer to the HP 70000 Modular Spectrum
Analyzer Programming Manual . However, user-dened functions can also be created,
modied
or
stored
using
information
from
the
\Programming-Related Softkey Descriptions".
Restricting Instrument Operation to User Softkeys
If you wish to restrict analyzer operation to the user softkeys, execute the USERLOCK ON
programming command via HP-IB, or execute USERLOCK ON using these front panel controls:
CA
UTION
Once
USERLOCK
is
on,
the
4
MENU
5
softkeys
can
be
reenabled
two
ways
only
,
either by executing the USERLOCK OFF command via HP-IB with the use of a
computer
,
or
by
using
the
N
N
N
N
N
N
N
N
N
N
NNNNNNNNNNNNN
COMMAND
softkeys
which
are
normally
accessed
with
the 4
MENU
5 key. Since USERLOCK ON deactivates the 4
MENU
5 key, the
N
N
N
N
NNNNNNNNNNNNNNNNNNN
COMMAND
softkeys must be transferred to the user-key menu before USERLOCK ON is
executed, if a computer is unavailable. (See Example 1-3.)
Example 1-5. Disable the 4
MENU
5 softkey.
1.
A
dd
the
N
N
N
N
N
N
N
N
NNNNNNNNNNNNNNN
COMMAND
softkey
to
the user menu, following the procedure in Example 1-3. (See
Caution
above
.)
2.
Press
4
USER
5
.
3.
Press
N
NNNNNNNNNNNNNNNNNNNNNN
COMMAND
,
then
spell
out
USERLOCK
ON by positioning the cursor underneath the
characters contained in the alphabet shown on the analyzer display. Press
N
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SELECT CHAR to
enter each letter into the data line. As each letter is entered, it appears in the data line at
the bottom of the analyzer screen. (The character for \space" is located after
Z .)
4.
After USERLOCK ON is entered into the data line, press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
ENTER COMMAND to execute the
USERLOCK ON function.
To reactivate the 4
MENU
5 key, execute USERLOCK OFF using the preceding procedure or a
computer program. Use the step-up key, 4
8
5 to position the cursor at the end of the data line.
For additional information, see \User-Dened Softkey Descriptions" and \Programming-Related
Softkey Descriptions" in Chapter 3.
Overview 1-25