6 Installing and troubleshooting
4. Install software
a Quit all open programs.
b Insert the CD-ROM. The installation program should start automatically.
If the installation program does not start: On the Start menu, click Run and
type: x:setup.exe, where x is the letter of the CD-ROM drive.
c Follow the directions on screen.
The installation program suggests which connection, USB or SCSI, you should
use.
5. Connect interface cable
a Turn off the computer.
b Choose ONE:
● Connect the USB cable between the USB ports on the scanner and the
computer.
● Connect the SCSI cable between the SCSI ports on the scanner and the
computer. Note: You MUST install the scanning software before
connecting a SCSI cable.
6. Connect the power cable
a Connect the power cable between the scanner and a surge protector or
grounded wall outlet that is easily accessible. This turns on the scanner.
(There is no power switch.)
b Turn on the computer.
If you see a dialog box informing you that new hardware has been found, follow
the directions on screen.
SCSI USB
To Next Page
Loading...