HP 9800 SERIES User Manual

78-78
80
81
82
83
8a
85
86
87
88
88
80
81 - 88
100
101
102
103
loa
9845B/C Mainframe References 10-5
Reserved for future use.
Cartridge
out or door open. Also check to see if interface is connected proper-
ly.
Mass storage device failure. Possible power failure.
Mass storage device not present. Check mass storage unit specifier.
Write protected. Check the write-protection device
on the medium or drive.
Record not found. There is a bad spot on the medium.
Mass storage medium is not initialized.
Not a compatible tape cartridge.
Record
address error; information can't be read. Hardware failure. Check for a
dirty
read head.
Read data error. Hardware failure. Check for a dirty read head.
Check read error.
Mass storage system error.
Reserved for future use.
Item
in print using list is string but image specifier is numeric.
Item in print using list
is numeric but image specifier is string.
Numeric field specifier wider than printer width.
Item in print using list has no corresponding image specifier.
ON KBD or TOPEN not allowed in subprogram.
105 - 108 Reserved for future use.
1 1
0 Plotter type specification not recognized. Check spelling of "GRAPHICS",
"9872A" or "INCREMENTAL".
1 1 1 Plotter has not been specified. Check select codes.
1 1 2 No graphics hardware installed in the System 45B.
1 1
3 LIMIT specifications out of range.
1 1 a 98036 card improperly configured.
1 1 5 TDISP not allowed unless peripheral keyboard active.
1 16 TOPEN is active on another select code.
117- 1 a8 Reserved for future use.
1 50 Improper select code.
1 5 1 A negative select
code was specified that does not match present bus address-
ing.
152
153
15a
155
156
Parity error.
Either insufficient input
data to satisfy enter list, attempt to ENTER from source
into source or enter count exhausted without linefeed.
Integer overflow, or ENTER count greater than 32 767 bytes or 16383 words.
Invalid interface register number. (Can only specify 4-7.)
Improper expression type
in READIO, WRITEIO, or STATUS list.
157 No linefeed was found to satify I ENTER image specifier, or no linefeed record
delimiter was found in 512 characters of input.
I

HP 9800 SERIES Specifications

General

Category	Storage
Series	9800 SERIES
Type	Disk Array
Drive Types Supported	SAS, SSD
RAID Levels Supported	0, 1, 5, 6, 10
Host Connectivity	Fibre Channel, iSCSI, SAS
Redundancy	Redundant power supplies and fans