Need help?Do you have a question about the HP EVA P6000 and is the answer not in the manual?
General| Model | HP EVA P6000 |
|---|---|
| Number of Storage Controllers | 2 |
| Management Software | HP Command View EVA |
| Drive Types | SAS, SSD |
| RAID Levels | RAID 0, 1, 5, 6 |
| Connectivity | 8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI |
| Form Factor | Rack-mounted |
| Storage Controller Type | Dual controllers |
Details on Small Form Factor (SFF) and Large Form Factor (LFF) SAS disk enclosures.
Details the controller enclosure components, including management and controller modules.
Details power distribution units (PDUs) and their role in powering the rack.
Provides essential safety warnings and procedures for moving and stabilizing racks.
Describes failback preference settings for HSV controllers and their behavior.
Explains how changing virtual disk settings impacts virtual disk presentation.
Explains component replacement and warranty service options.
Provides instructions on how to safely replace a failed component.
Covers general rules for iSCSI Initiators and ports, including IP subnet requirements.
Provides instructions for setting up the iSCSI Initiator on Windows operating systems.
Outlines switch zoning and presentation requirements for HP-UX single path HBAs.
Details zoning and SSP requirements for single path HBAs in Windows Server.
Specifies zoning and SSP requirements for Oracle Solaris single path HBAs.
Outlines zoning and access path requirements for OpenVMS nodes.
Details zoning and access path requirements for Xen servers.
Specifies zoning and path requirements for Linux 32-bit configurations.
Outlines zoning and path requirements for Linux Itanium configurations.
Details zoning and presentation requirements for IBM AIX single path HBAs.
Specifies zoning and access path requirements for VMware configurations.
Information on Mac OS connectivity and Fibre Channel.
Details failure stimuli and their effects on different operating systems.
Provides initial checks and diagnostic steps for disk enclosure initialization issues.
Provides steps to follow after a disk drive failure, including hot-plug drives.
Explains self-test and operational status indicated by MEZZ LEDs.
Provides common issues and their corresponding solutions for HP P6000 Command View.
Adds, modifies, and removes an initiator in the module’s database.
Configures general iSCSI/iSCSI/FCoE parameters and module-specific settings.
Displays module operational information and configuration details.
Covers key tasks like modifying, backing up, and restoring configurations.
Explains how to save module configurations for backup or template use.
To Next Page