System Information
--------------------
Product Name HP StorageWorks MEZ50
Symbolic Name MEZ50-1
System Mode iSCSI Server Connectivity
Controller Slot Left
Controller Lun AutoMap Enabled
Target Access Control Disabled
Serial Number 1808ZJ03297
HW Version 01
SW Version 3.0.3.9
Boot Loader Version 1.1.1.9
No. of FC Ports 2
No. of iSCSI Ports 4
Telnet Enabled
SSH Enabled
Temp (C) 36
MEZ50 (admin) #>
Working with iSCSI or iSCSI/FCoE module configurations
Successfully managing iSCSI and iSCSI/FCoE modules with the CLI depends on effective module
configurations. Key module management tasks include modifying configurations, backing up
configurations, and restoring configurations.
Status viewing through the use of the show commands can be quite helpful in collecting information
needed to resolve problems.
• show fc
• show iscsi
• show perf
• show stats
• show luns
• show luninfo
• show initiators
• show initiators_lunmask
• show targets
• show presented_targets
• show system
• show logs nn
NOTE: Mapping and unmapping LUNs through the CLI is likely to result in inconsistencies with
HP P6000 Command View and is not recommended by HP. There may be cases where a CLI reset
mappings is a more effective method of addressing these inconsistencies than using the CLI lunmask
add or lunmask rm commands.
248 Using the iSCSI CLI
To Next Page
Loading...
Need help?
General
