HP EVA P6000 User Manual

8 Error messages
This list of error messages is in order by status code value, 0 to 243.
Table 23 Error Messages
How to correctMeaningStatus code value
No corrective action required.The SCMI command completed successfully.0
Successful Status
Delete the associated object and try
the operation again. Several situations
can cause this message:
Presenting a LUN to a host:
• Delete the current association or
specify a different LUN number.
Storage cell initialize:
• Remove or erase disk volumes
before the storage cell can be
successfully created.
Adding a port WWN to a host:
• Specify a different port WWN.
Adding a disk to a disk group:
• Delete the specified disk volume
before creating a new disk volume.
The object or relationship already exists.1
Object Already Exists
Report the error to product support.The command or response buffer is not large
enough to hold the specified number of
2
Supplied Buffer Too Small
items. This can be caused by a user or
program error.
Report the error to product support.This error is no longer supported.3
Object Already Assigned
Reclaim some logical space or add
physical hardware.
There is insufficient storage available to
perform the request.
4
Insufficient Available Data
Storage
Report the error to product support.An unexpected condition was encountered
while processing a request.
5
Internal Error
Report the error to product support.This error is no longer supported.6
Invalid status for virtual disk
Report the error to product support.The supplied class code is of an unknown
type. This can be caused by a user or
program error.
7
Invalid Class
Report the error to product support.The function code specified with the class
code is of an unknown type.
8
Invalid Function
Report the error to product support.This error is no longer supported.9
Invalid Logical Disk Block State
Report the error to product support.This error is no longer supported.10
Invalid Loop Configuration
Report the error to product support.There are insufficient resources to fulfill the
request, the requested value is not
11
Invalid parameter
supported, or the parameters supplied are
invalid. This can indicate a user or program
error.
162 Error messages

HP EVA P6000 Specifications

General

Model	HP EVA P6000
Number of Storage Controllers	2
Management Software	HP Command View EVA
Drive Types	SAS, SSD
RAID Levels	RAID 0, 1, 5, 6
Connectivity	8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI
Form Factor	Rack-mounted
Storage Controller Type	Dual controllers