HP EVA P6000 User Manual

Figure 44 Target login
5. Click the Connected Targets tab, and then click the Toggle Start-Up button on each target
listed so the targets start automatically (Figure 45 (page 99)).
Figure 45 Connected Targets tab
Installing and configuring for Red Hat 5
To install and configure for Red Hat 5:
NOTE: The iSCSI driver package is included but is not installed by default. Install the package
iscsi—initiator—utils during or after operating system installation.
Set up the iSCSI Initiator 99

HP EVA P6000 Specifications

General

Model	HP EVA P6000
Number of Storage Controllers	2
Management Software	HP Command View EVA
Drive Types	SAS, SSD
RAID Levels	RAID 0, 1, 5, 6
Connectivity	8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI
Form Factor	Rack-mounted
Storage Controller Type	Dual controllers