Table 1 HSV340/360 controller port status indicators
DescriptionPort
Fibre Channel host ports
• Green — Normal operation
• Amber — No signal detected
• Off — No SFP
1
detected or the Direct Connect HP P6000 Control Panel
setting is incorrect
Fibre Channel device ports
• Green — Normal operation
• Amber — No signal detected or the controller has failed the port
• Off — No SFP
1
detected
1
On copper Fibre Channel cables, the SFP is integrated into the cable connector.
Table 2 HSV340/360 FC-iSCSI controller port status indicators
DescriptionPort
Fibre Channel switch ports
• Green on — Normal operation or loopback port
• Green flashing — Normal online I/O activity
• Amber on — Faulted port, disabled due to diagnostics or Portdisable
command
• Amber flashing — Port with no synchronization, receiving light but not yet
online or segmented port
• Off — No SFP
1
, no cable, no license detected.
Fibre Channel device ports
• Green — Normal operation
• Amber — No signal detected or the controller has failed the port
• Off — No SFP
1
detected
1
On copper Fibre Channel cables, the SFP is integrated into the cable connector.
Controller status LEDs
Figure 8 (page 25) shows the location of the controller status LEDs; Table 3 (page 25) describes
them.
NOTE: Figure 8 (page 25) shows an FC-iSCSI controller, however the LEDs for the FC, FC-iSCSI,
and iSCSI/FCoE controllers are identical, unless specifically noted.
Figure 8 Controller status LEDs
Table 3 Controller status LEDs
IndicationLEDItem
Blue LED identifies a specific controller within the enclosure or
identifies the FC-iSCSI or iSCSI/FCoE module within the controller.
1
Green LED indicates controller health. LED flashes green during
boot and becomes solid green after boot.
2
Controller enclosure 25
To Next Page