1. Enter the CLI command beacon on (see Figure 73 (page 157)).
Figure 73 Beacon on command
2. 2. In HP P6000 Command View, click the General tab and then click the Locate button. Use
the Locate ON and Locate OFF buttons to control the blue LED (see Figure 74 (page 157)).
Figure 74 Locate Hardware Device
iSCSI or iSCSI/FCoE module's log data
The iSCSI or iSCSI/FCoE modules maintain logs that can be displayed or collected through the
CLI. The log is persistent through reboots or power cycles. To view the log use the CLI command
show logs.
See “iSCSI or iSCSI/FCoE module log messages” (page 266) for log data descriptions.
iSCSI or iSCSI/FCoE module statistics
Statistics are available via the iSCSI or iSCSI/FCoE module CLI for the iSCSI and Fibre Channel
ports. To view the statistics us the CLI command show stats.
Troubleshoot using HP P6000 Command View
HP P6000 Command View can display the properties for each iSCSI module. At a glance, you
can check each module’s software revision, serial number, temperature, and power/cooling status
(see Figure 75 (page 158)).
iSCSI module diagnostics and troubleshooting 157
To Next Page
Loading...
Need help?
General
