Save
Saves logs and traces.
Admin sessionAuthority
capture
logs
traces
saveSyntax
The save capture command creates a debug file that captures
all debug dump data. After the command completes, you must FTP
the debug capture file from the module.
captureKeywords
The save logs command creates a tar file that contains the
module’s log data, storing the file in the module’s /var/ftp
logs
directory. After the command completes, you must FTP the log’s tar
file from the module.
The save traces command creates a tar file that contains the
module’s dump data, storing the tar file in the module’s /var/ftp
traces
directory. After the command completes, you must FTP the trace’s
tar file from the module. After executing this command, the system
notifies you if the module does not have any dump data. Each time
it generates dump data, the system adds an event log entry.
Example 1:
MEZ50 <1>(admin) #> save capture
Debug capture completed. Package is System_Capture.tar.gz
Please use FTP to extract the file out from the System.
Example 2:
MEZ50 <1>(admin) #> save logs
Save Event Logs completed. Package is System_Evl.tar.gz
Please use FTP to extract the file out from the System.
Example 3: Save traces is not supported by the iSCSI or iSCSI/FCoE modules.
MEZ50 (admin) #> save traces
Save ASIC Traces failed.
Set
Configures general iSCSI or iSCSI/FCoE parameters, as well as parameters that are specific to
the FC, iSCSI, and management ports.
iSCSI/FCoE moduleiSCSI moduleCommand
alias
chap
alias
chap
Set
fc [<PORT_NUM>]features
features
iscsi [<PORT_NUM>]
iscsi [<PORT_NUM>]isns
isnsmgmt
mgmtntp
ntpproperties
propertiessnmp [trap_destinations [<DEST_NUM>]]
system snmp [trap_destinations [<DEST_NUM>]]
system
vpgroups [vpgroup index]
Commands 213
To Next Page
Loading...
Need help?
General
