Figure 75 iSCSI and iSCSI/FCoE module properties
Issues and solutions
Issue: HP P6000 Command View does not discover the iSCSI or iSCSI/FCoE modules
Solution 1: Ensure that a DHCP server is available.
Solution 2: Set a static IP address on each iSCSI and iSCSI/FCoE module through the CLI.
Solution 3: Ensure the HP P6000 Command View station is on the same subnet of the management
ports.
Solution 4: Enter the known IP address of the management port of the iSCSI modules in the HP
P6000 Command View discovery screen.
Issue: Initiator cannot login to iSCSI or iSCSI/FCoE module target
Solution 1: Ensure the correct iSCSI port IP address is used
Solution 2: In HP P6000 Command View, , for each iSCSI controller 01 and 02, click the IP ports
tab, then expand the TCP properties under the Advanced Settings. There should be available
connections; if not, choose another IP port to log in to or reduce the connections from other initiators
by logging out from unused connections (see Figure 76 (page 159)).
158 Troubleshooting
To Next Page
Loading...
Need help?
General
