HP EVA P6000

Figure 55 HBA Port Target Configuration
3. Repeat Steps 1 and 2 to add each additional iSCSI or iSCSI/FCoE target iSCSI port.
4. Click Next.
5. To enable the changes, enter the SMS password: config.
6. Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and each target
entry’s state is Session Active (Figure 56 (page 115)).
Figure 56 Target Settings tab
Presenting LUNs to the QLogic iSCSI Initiator
To present LUNs to the QLogic iSCSI Initiator:
Set up the iSCSI Initiator 115