3–6
Check the Hardware Installation
Perform the following steps to check the hardware installation:
CAUTION: The CD-ROM drive is susceptible to mechanical and electrostatic
shock. When handling the drive, always wear the static strap that came
in the CD-ROM drive kit. Always handle the drive carefully.
1. Check that the SCSI terminator is connected to the single-ended SCSI port on the rear
I/O panel of the system unit (if there are no external SCSI devices), or that the last
external single-ended SCSI device is terminated.
2. Attach the static-grounding wrist strap by following the instructions on the package that
contains the strap.
3. Shut down HP-UX.
NOTICE: If you are already at the boot administration level, you do not need to
shut down; skip this step and go on to Step 4.
If you are running HP-UX under HP VUE, shut down your system by performing the
shutdown procedure described in the System Owner’s Guide which came with your
workstation.
If you are running HP-UX without HP VUE, shut down your system by typing the fol-
lowing command:
# /etc/shutdown –h
RETURN
You must have superuser privileges to use the /etc/shutdown command. If you do not
have superuser privileges, contact your system administrator.
If your workstation is part of a cluster, refer to the manual, Managing Clusters of HP
9000 Computers
for instructions on shutting down.
4. Power off the workstation, using the power switch on the front of the workstation.
To Next Page
Loading...
Need help?
General