Need help?Do you have a question about the HP HPE Alletra 6030 and is the answer not in the manual?
General| Form Factor | 2U |
|---|---|
| Drive Types | SSD |
| Max Number of Drives | 24 |
| RAID Support | Yes |
| Operating System | HPE Alletra OS |
| Replication | Synchronous and Asynchronous |
| Controller Type | Dual controller |
| Networking | 10GbE, 25GbE, 40GbE, 100GbE |
| Product Type | Storage Array |
| Host Interface | iSCSI, FC |
| Data Services | Snapshots |
Guidance for preparing storage array installation, covering network topology and IP addresses.
Overview of managing arrays via Data Services Cloud Console and HPE GreenLake.
Procedure for initial setup using a Windows host and the Setup Manager tool.
Procedure for initial setup using the Command Line Interface (CLI).
Procedure to shut down the array using the Graphical User Interface (GUI).
Procedure to shut down the array using the Command Line Interface (CLI).
Explanation of normal Active/Standby controller status for redundancy.
Steps to connect and activate the expansion shelf after configuration.
Procedures for maintaining drives, including handling failed drives.
Step-by-step guide to replacing SSDs in the storage array or expansion shelf.
Procedures for maintaining controller components like NICs, HBAs, SCM, and fans.
Procedure for replacing a controller in the HPE storage array.
Procedure to switch array management from active to standby controller via GUI.
Procedure to switch array management from active to standby controller via CLI.
Procedure to add SSDs to increase capacity in the HPE storage array.
Procedure to upgrade controllers in the HPE storage array to newer models.
To Next Page