©2015 Recycler Publishing & Events Ltd THE RECYCLER - TECHNICAL GUIDE PAGE 9
With the drum cover spring as shown on the end cap,
install the end cap. Lift up the tail of the spring to t onto
the hopper.
Lift up the drum cover sprint tail to t as shown
on the drum cover. Install the screw into the
cover.
Replace the chip by slicing off the melted chip rails.
If the chip seems loose upon installation, you can
place small dabs of hot glue on the corners to hold
it in place.
STEP TWENTY-EIGHT
STEP TWENTY-NINE
STEP THIRTY
Repetitive defect chart
OPC drum 75mm
Upper fuser lm 57mm
Lower pressure roller 56mm
Transfer roller 39mm
Magnetic roller 34mm
PCR 27mm
To Next Page
Loading...
