Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-3 Solid-state drive description and part number
Description Spare part number
Solid-state drive, 256 GB M11042-002
Solid-state drive, 128 GB M11040-002
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 26).
2. Remove the bottom cover (see Bottom cover on page 26).
3. Remove the battery (see Battery on page 27).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 3.0 screw (1) that secures the drive to the computer.
2. Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Speakers
To remove the speakers, use this procedure and illustration.
Table 5-4 Speaker description and part number
Description Spare part number
Speaker Kit M00436-001
Before removing the speakers, follow these steps:
Component replacement procedures 29
To Next Page
Loading...
