Storing supplies
Follow these guidelines for storing print cartridges:
●
Do not remove the print cartridge from its package until it is ready for use.
CAUTION To prevent damage, do not expose the print cartridge to light for more than a
few minutes.
●
Store the supply in a location where the temperature is within the recommended temperature
range.
●
Store the supply in a horizontal position.
●
Store the supply in a dark, dry location away from heat and magnetic sources.
Replacing and recycling supplies
When installing a new HP print cartridge, follow the instructions included on the new supply's box, or
see the Getting Started Guide.
When recycling supplies:
●
Place the used supply in the box in which the new supply arrived
●
Complete the enclosed return label
●
Send the used supply to HP for recycling
For complete information, see the recycling guide included with each new HP supply item.
HP policy on non-HP supplies
Hewlett-Packard Company cannot recommend the use of non-HP supplies, either new or
remanufactured. When they are not HP products, HP cannot influence the product design or quality.
Service or repair required as a result of using a non-HP supply is not covered under the MFP
warranty.
When inserting a supply into the MFP, the MFP displays whether or not the supply is a genuine HP
supply. When a genuine HP is inserted and that supply has reached the low state from another
HP MFP, the MFP identifies the supply as non-HP. Simply return the supply to the original MFP to
reactivate HP features and functionality.
Reset the MFP for non-HP supplies
When a non-HP print cartridge is installed, a question mark appears in the displays above the
cartridge that is non-HP. To print with this supply press OK the first time this non-HP supply is
installed. The status gauges do not indicate when this type of supply is low or empty.
CAUTION The MFP may not stop printing with non-HP supplies. MFP damage can occur if
the MFP prints with an empty print cartridge.
ENWW Managing supplies 25
To Next Page
Loading...