HP CM1015 MFP

Printing-system software installation
This section contains information about the following topics:
●
Animated Getting Started Guide
●
Printing-system software installation for Microsoft Windows 2000 and Microsoft Windows XP
●
Printing-system software installation for Microsoft Windows Server 2003
Animated Getting Started Guide
When you insert the printing-system software CD into the CD-ROM drive, the Animated Getting Started
Guide starts automatically.
NOTE If the Animated Getting Started Guide does not start automatically, click Start, Run,
type X://autorun.exe( where X is the letter of the CD drive), and then click OK.
The Begin Setup screen appears, as shown in the following illustration.
Figure 3-1 Animated Getting Started Guide – Begin Setup screen
Click Begin Setup to initiate a series of screens that show how to prepare the HP Color
LaserJet CM1015 MFP/CM1017 MFP for software installation. Click the arrows in the lower-right corner
of the screen to view animated illustrations of each step.
Click Index to see a list of setup topics in the Animated Getting Started Guide. Or if the HP Color
LaserJet CM1015 MFP/CM1017 MFP has already been set up or is already installed on a network,
click Install Software to install the print drivers and other software features.
When setup is complete, the Install Software screen appears.
134 Chapter 3 Install Microsoft Windows printing-system components ENWW
Microsoft Windows
install