HP CM3530 - Color LaserJet MFP Laser Fax Guide

Introduction
The HP LaserJet Analog Fax Accessory 500 enables the HP multifunction product (MFP) to function as
a standalone analog fax machine. For more information, see
www.hp.com/go/mfpfaxaccessory500.
This guide describes the fax functions of this product and provides information on product specifications
and regulatory information.
NOTE: In addition to the analog fax feature, the MFP also supports LAN faxing. LAN faxing is managed
by the HP MFP Digital Sending Software Configuration Utility which is a separate product and is not
covered in this document. For information about LAN faxing, see the HP MFP Digital Sending Software
User Guide or the HP MFP Digital Sending Software Support Guide. If both the analog fax accessory
and the LAN fax are installed, only one fax can be enabled at a time.
You should save this guide so that you can refer back to instructions on specific fax features.
NOTE: If the MFP came with the fax accessory installed, you need to remove the fax connection cover,
connect the phone cord, and then perform the initial fax configuration. The fax connection cover is
located on the phone connector on the formatter rear panel.
2 Chapter 1 Setup ENWW

HP CM3530 - Color LaserJet MFP Laser Specifications

General

Print Technology	Laser
Print Speed Black	31 ppm
Print Speed Color	31 ppm
Copy Speed Black	31 cpm
Copy Speed Color	31 cpm
Fax Resolution	Up to 300 x 300 dpi
Fax Speed	33.6 kbps
Processor Speed	600 MHz
Duplex Printing	Automatic
Functions	Print, Copy, Scan, Fax
Network Connectivity	Ethernet
Print Resolution	600 x 600 dpi
Memory	256 MB
Hard Disk	Optional
Connectivity	USB, Ethernet
Paper Handling	100-sheet multipurpose tray
Operating System Compatibility	Windows, macOS
Monthly Duty Cycle	75, 000 pages