5. Remove one screw (callout 2), and then remove the cover (callout 3).
Figure 6-73 Remove the right-door assembly (5 of 8)
2
3
6. Disconnect two connectors (callout 4), and then release the wire harness from the guide (callout 5).
TIP: It is easier to disconnect the lower connector if you first remove the wire harnesses from the
guide.
Figure 6-74 Remove the right-door assembly (6 of 8)
4
5
ENWW External panels, covers, doors, and scanner assembly 229
To Next Page
Loading...
