Fuser-drive assembly
Before proceeding, remove the following components:
●
Formatter PCA.
Formatter PCA on page 192.
●
Fuser. See
Fuser on page 200.
●
Secondary transfer assembly. See
Secondary transfer assembly on page 207.
●
Front-upper cover. See
Front-upper cover on page 225
●
Right-rear cover. See
Right-rear cover on page 231.
●
Left cover. See
Left cover on page 233.
●
Rear-upper cover. See
Rear-upper cover on page 236.
●
Rear cover. See
Rear cover on page 238.
●
Scanner assembly. See
Scanner assembly on page 242.
●
Front-top cover. See
Front-top cover on page 261.
●
Rear-top cover. See
Rear-top cover on page 262
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 267.
TIP: For internal product access, you can remove the ICB and the low-voltage power supply as
a single component.
●
DC controller PCA. See
DC controller PCA and tray on page 270.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 273.
●
Power-supply fan and fan duct. See
Power-supply fan and fan duct on page 300.
●
High-voltage power supply lower. See
High-voltage power supply lower on page 308.
●
High-voltage power supply upper. See
High-voltage power supply upper on page 339.
●
Main-drive assembly. See
Main-drive assembly on page 346.
356 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...
