5. Disconnect one connector (callout 7), remove two screws (callout 8), and then carefully lift the
assembly (callout 9) off of the product to remove it.
CAUTION: A solenoid arm (on the right side) and a spring (on the left side) on the assembly are
not captive. Do not lose the solenoid arm or spring when you remove the assembly. If the solenoid
arm or spring become dislodged, see
Reinstall the delivery assembly on page 365.
Figure 6-293 Remove the delivery assembly (5 of 5)
7
9
8
364 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...
