F output bin full sensor
NOTE: Upper-front cover has been removed for clarity.
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser.
4. Move the output-bin full sensor flag.
Figure 7-9 Test the output-bin-full sensor
5. Check the control-panel display for sensor response.
6. If no response, remove the control panel and verify that the flag is moving. If not, replace the delivery
assembly. If the sensor is malfunctioning, replace the delivery assembly. See
Delivery assembly
on page 361.
ENWW Tools for troubleshooting 393
To Next Page
Loading...
