Control panel message Description Recommended action
Manually Feed: [Type], [Size] To continue,
touch OK
A job has specified manual feed, and Tray 1
is loaded.
Touch OK to resume printing.
Manually Feed: [Type], [Size] To use
another tray, touch OK
The job specified manual feed, the MP-tray is
empty, and there is another tray available to
use.
Touch OK to switch to another tray and
resume printing.
Moving solenoid To exit press STOP The solenoid and a motor are moving as part
of a component test.
No action is necessary.
No job to cancel This message appears when the Stop button
is pressed.
No action is necessary.
Non-HP supply installed A refilled color or a cloned color/mono
cartridge was installed, and the product
previously used all genuine HP supplies. Or,
an unauthorized cartridge was installed, and
the product previously used all genuine
supplies.
Install a genuine HP cartridge, or touch OK to
override the condition.
Non-HP supply in use This message appears when the override
button is pressed (on the non-HP supply
installed error).
No action is necessary.
Order <color> Cartridge The identified print cartridge is nearing the
end of its useful life. The product is ready and
will continue for the estimated number of
pages indicated. Estimated pages remaining
is based upon the historical page coverage of
this product.
Printing will continue until a supply needs to
be replaced.
Order a replacement print cartridge.
Order Fuser Kit The fuser is near the end of life. The product
is ready and will continue for the estimated
number of pages indicated. Printing will
continue until a supply needs to be replaced.
Order a replacement fuser kit.
Order roller kit-Less than XXXX pages The roller kit is low due to rotations. Order a replacement roller kit.
Order Supplies One or more supplies need to be replaced. Replace the supply.
Order toner collection unit The toner collection unit is almost full. Order a replacement toner collection unit.
Order Transfer Kit The transfer kit is near the end of life. Printing
can continue.
Order a replacement transfer kit.
Order transfer kit Less than XXXX pages The number of pages remaining for this
supply has reached the low threshold.
Printing can continue.
Order a replacement transfer kit.
Approximate pages remaining will vary
depending on the types of documents
printed.
Performing Color Band Test The color-band test is being performed. No action is necessary.
Performing paper path test Press stop to
cancel
The product is performing a paper-path test. No action is necessary.
Performing upgrade <Device> The product is performing a product upgrade. Do not turn the product off or press any
buttons. The product will automatically restart
when the upgrade is finished.
Please wait The product is going offline. No action is necessary.
Printing The page is being printed. No action is necessary.
Table 7-12 Control-panel messages (continued)
ENWW Control-panel messages 461
To Next Page
Loading...
