Screws
NOTE: The screw illustrations in the following table are for reference only. Screws might vary in size
and appearance from those shown in this table.
Table 8-8 Common fasteners
Example Description Size Part Number
Screw, with washer M3x8 XA9-1420-000CN
Screw, tapping, truss head M4x10 XB4-7401-005CN
Screw, tap M3x6 XA9-1503-000CN
Screw, D M3x8 XA9-1671-000CN
Screw, tooth washer M4x6 XB2–7400-606CN
12 mm
How to use the parts lists and diagrams
The figures in this chapter show the major subassemblies in the product and their component parts. A
parts list table follows each exploded view assembly diagram. Each table lists the item number, the
associated part number, and the description of each part. If a part is not listed in the table, then it is not
a field replacement unit (FRU).
CAUTION: Be sure to order the correct part. When looking for part numbers for electrical components,
pay careful attention to the voltage that is listed in the description column. Doing so will ensure that the
part number selected is for the correct all-in-one model.
NOTE: In this manual, the abbreviation “PCA” stands for “printed circuit-board assembly.”
Components described as a PCA might consist of a single circuit board or a circuit board plus other
parts, such as cables and sensors.
ENWW Screws 519
To Next Page
Loading...
