Menu item Sub-menu item Values Description
Full Calibration Calibrate Performs all product calibrations.
Delay Calibration at
Wake/Power On
No
Yes (default)
This menu controls the timing of the calibration when
the printer wakes up or is turned on.
●
Select No to have the printer calibrate immediately
when it wakes up or is turned on. The product will
not print any jobs until it finishes calibrating.
●
Select Yes to enable a product that is asleep to
accept print jobs before it calibrates. The product
only accepts new jobs for a short time. It may start
calibrating before it has printed all the jobs it has
received.
NOTE: For the best results, allow the product to
calibrate before printing. Print jobs performed before
calibration may not be of the highest quality.
Table 2-16 Print Quality menu (continued)
ENWW Print Quality menu 49
To Next Page
Loading...
