HP CM4730 MFP

Declaration of Conformity
Declaration of Conformity
according to ISO/IEC 17050–1 and EN 17050–1
Manufacturer's Name: Hewlett-Packard Company
DoC#: BOISB-0503–00–rel. 2.0
Manufacturer's Address: 11311 Chinden Boulevard,
Boise, Idaho 83714-1021, USA
declares that the product
Product Name: HP Color LaserJet CM4730 MFP series
Accessories
Q7521A, Q7522A, Q7523A, BOISB-0308–00
3)
Regulatory Model Number:
2)
BOISB-0503-00
Product Options: ALL
Toner Cartridges: Q6460A, Q6461A, Q6462A, Q6463A, Q7504A, Q7503A, Q7502A
conforms to the following Product Specifications:
Safety: IEC 60950-1:2001 / EN60950-1: 2001 + A11
IEC 60825-1:1993 +A1 +A2 / EN 60825-1:1994 A1 +A2 (Class 1 Laser/LED Product)
GB4943-2001
EMC:
CISPR 22:1993 A1+A2 / EN 55022:1994 +A1 +A2 – Class A
1,4)
EN 61000-3-2:2000
EN 61000-3-3:1995 + A1:2001
EN 55024:1998+A1:2001 + A2:2003
FCC Title 47 CFR, Part 15 Class A / ICES-003, Issue 4
GB9254-1998, GB17625.1–2003
Supplementary Information:
The product herewith complies with the requirements of the EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC, and carries
the CE-Marking accordingly.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
1) The product was tested in a typical configuration with Hewlett-Packard Personal Computer Systems.
2) For regulatory purposes, this product is assigned a Regulatory model number. This number should not be confused with the product name
or the product number(s).
3) All worldwide modular approvals for analog fax accessory obtained by Hewlett-Packard under the regulatory model number BOISB-0308–
00 incorporate the Multi-Tech Systems MT5634SMI Socket Modem Module.
4) The product meets the requirements of EN55022 & CNS13438 Class A in which case the following applies: “Warning – This is a class A
product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate
measures”.
Boise, Idaho , USA
October 17, 2006
For regulatory topics only:
European Contact: Your Local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, Department HQ-TRE / Standards
Europe, Herrenberger Straße 140, D-71034 Böblingen, Germany, (FAX: +49-7031-14-3143)
USA Contact: Product Regulations Manager, Hewlett-Packard Company, PO Box 15, Mail Stop 160, Boise, Idaho 83707-0015, USA,
(Phone: 208-396-6000)
ENWW Declaration of Conformity 319