Covers
To specify cover settings, click Covers on the Special Pages window, then click Settings.
Use the Covers options to include a blank or preprinted cover on a document or to include a front/back
cover from a source tray that is different from the one used for the remainder of the document.
The following are the Covers options:
●
Add a blank or preprinted cover: Select which cover is customized: Front, Back, or Both.
●
Paper source: The Paper source setting specifies the source tray to use for adding a front and/
or back cover to the document. The list of source trays depends on the accessories that are
installed. Any optional trays that are installed through the Device Settings tab also appear here.
●
Paper type: The Paper type setting specifies the paper size to use for front and/or back covers.
Changes made to the Paper type setting here override any previous Paper type settings using
the same paper source.
NOTE: The Back Cover options are not available when the Booklet Printing Layout setting is
enabled on the Finishing tab. The back cover setting is unavailable, because this page would be printed
in the middle of a booklet.
NOTE: The same size of paper will be used for the entire print job.
When you change the type and source of the paper and covers, the settings remain configured until you
close the software program.
Print pages on different paper
Use the Print pages on different paper options to select an alternative paper type or source for the
first or last page of a document.
160 Chapter 4 HP PCL 6 Print Driver for Windows ENWW
To Next Page
Loading...
