8. The update process is complete when an icon appears in the lower-right corner of the dialog box.
Also, check that the product is in a ready state before continuing. A smiling icon appears when the
update completes successfully; a frowning icon appears when the update does not complete
successfully.
NOTE: If the frowning icon appears, check to make sure the product is on and in a Ready state.
Verify that you can send print jobs to the product, and then try again to perform the firmware update.
Figure 6-3 HP Easy Firmware Upgrade utility complete screen
9. Click Exit to close the dialog box.
10. Turn the product off and then turn it on again, if you are instructed to do so on the control panel.
11. When the product is in a Ready state, print a configuration page and verify that the firmware version
has changed.
Other remote firmware update methods
●
Remote firmware update by using FTP through a browser
●
Remote firmware update by using FTP on a network connection
●
Remote firmware update through a Windows network
●
Remote firmware update for UNIX systems
●
Remote firmware update by using the LPR command
●
Remote firmware update by using HP Web Jetadmin
●
Remote firmware update by using the HP Embedded Web Server
●
Messages during the firmware update
264 Chapter 6 Engineering details ENWW
To Next Page
Loading...
