8. Reconnect the power cable and USB or network cable, and then turn on the printer.
9. After installing a memory DIMM, see
Enabling memory on page 29.
Enabling memory
If you installed a memory DIMM, set the printer driver to recognize the newly added memory.
To enable memory for Windows
1. On the Start menu, point to Settings, and click Printers or Printers and Faxes.
2. Select this printer and select Properties.
3. On the Configure tab, click More.
4. In the Total Memory field, type or select the total amount of memory that is now installed.
5. Click OK.
6. Go to
Checking DIMM installation on page 29.
Checking DIMM installation
Check that the DIMMs are installed correctly and working.
To check DIMM installation
1. Turn the printer on. Check that the printer is in the Ready state after it has gone through the
startup sequence. If an error message appears, a DIMM might have been incorrectly installed.
2. Print a configuration page. See
Using printer information pages on page 40.
3. Check the Installed Personalities and Options section on the configuration page and compare it
with the configuration page that you printed before the DIMM installation.
4. If the information on the configuration page has not changed, one of the following situations
exists:
The DIMM might not be installed correctly. Repeat the installation procedure.
-or-
The DIMM might be defective. Try a new DIMM.
ENWW Printer memory 29
To Next Page
Loading...