EN
Control panel messages
5
1
The printer is canceling the current print job. Incoming data for the
current job will be discarded.
• No action is required.
The printer cannot duplex because the rear output bin is open or the
media is not supported by the duplex-printing accessory.
1
Close the rear output bin.
2
Verify that the media is supported by the duplex-printing accessory.
The printer is performing an internal test. This process should take
approximately 30 seconds. The message is displayed during the
initiation of the engine test. When finished, the printer goes online.
• No action is required
The printer has jammed or was turned on and media was detected in
the paper path. The printer is attempting to clear these pages.
• No action is required.
Canceling job
Cannot duplex check rear bin
alternates with
Cannot duplex check paper
Checking printer
Clearing paper from printer
To Next Page
Loading...